Pre-Install Device Setup

Step 1: Plug in the 9v cable (C) to the Nauto device, inserting the end without a clip. Be sure the block square on the 9v cable goes INSIDE the mounting walls of the Nauto device.

preInstall2.png
 

Step 2: Attach the windshield mount to the Nauto device. Line up the teeth on the mount to the receivers on the device. Once lined up, simply slide the mount forward to lock.

NOTE: If you are installing in a van, bus, or truck, you may need to use a different mounting bracket than the one in the box. If you are unsure of which bracket to use, call our customer service (888)628-8606.

 

Step 3: Inspect the Nauto device setup. The device should look like the following photo